We are searching data for your request:
Rule 8cm by 8cm on sheet metal with the metal ruler and a scribe
Cut sheet metal on the line you marked with the scribe
Rule from corner to corner to find the centre then use the centre punch to make a hole
Use the divider to make a circle for you dishes
Use the tin snips to cut out the circle
File the sheet metal so that it's smooth all the way round
Drill a hole in the centre with the drill press
Use the tin mans mallet to make the sheet metal curved
Sand the sheet metal so that the paint stays on
Now mark the second piece of sheet metal with the scribe.
Use the guillotine to cut the sheet metal on the line.
Now use the metal ruler and a scribe to line from corner to corner to find the centre then use a centre punch to make a mark in the middle
Use the divider to mark a perfect circle on your sheet metal
Use the tin snips to cut out the circle.
Use the file to file down the edges of the sheet metal and make it smooth.
Use a clamp to hold your sheet metal and use the drill press the make a hole in the centre.
Use the tinmans mallet to mould the sheet metal so it's dented and can catch the wax
When it's deep enough use sandpaper to sand down the dish
Now mark your first piece of flat bar with a metal ruler and scribe 15cm long
Use a hacksaw to cut on the line to make your first piece
Now file down the ends with the file so there smooth
Put the scroll plate in a vice and scroll one end of your first piece
Now put it in the vice and use the ball pein hammer to bend the metal
Rule your second piece 15cm long
Use the hacksaw the cut the second piece
File down both ends with the file so they are smooth
Put your piece in the scroll plate and scroll one end of your second piece
Use the pall pein hammer to end the second piece
Now rule off 19cm with the scribe for your third piece
Use the hacksaw to cut off your third piece
File down both ends with the file so that there smooth
Use the scroll plate to scroll both sides of your third piece
Now rule off 19cm for your fourth piece
Now use the hacksaw to cut off your fourth piece
File down both ends with the file so there smooth
Use the scroll plate to scroll both sides of the fourth piece
Now rule off two 11cm pieces for your feet
Now use the hacksaw to cut off both of your feet
File down both sides of both of your feet so there smooth
Bend both sides of both feet so that the feet stand
Use the drill press to drill the holes in all your pieces First piece: on the flat bit of the end Second piece: same as the first Third piece: On top and bottom on the sides
Fourth piece: Same as third Feet: on the ends before the bends
Put the pop rivets in all the holes and use the pop rivet gun to make them clamp the pieces together.
Now sand down your candle holder so it's ready to spray